User Manual

8
1. Step 2
Connect the antenna adapter plug between the original antenna connector and the
radio. If there is still a blue wire attached to the antenna overflow, it can be linked
with AMP CON or ANT (often also a blue wire). This ensures that the antenna
amplifier is powered / activated.
1. Step 3
Place the Wi-Fi antenna if your model is over a separate
Antenna has as shown here. You can place the antenna in a place as high as possible
under the dashboard. Before you permanently stick it, you can check whether the radio
can find enough WIFI points. You can check this via settings – WIFI.
Make sure that the GPS and Wi-Fi antenna are connected to the correct connection. These can have
the same connector.
1. Step 4
Insert the GPS antenna. Connect the antenna connector to the back of the radio. The block that
ensures the reception of satellites should be placed as high as possible for optimal for the reception
of satellites should be placed as high as possible for an optimal range. You can place it behind the
interior mirror, on top of the dashboard or above the radio just below dashboard. If you place the
GPS antenna under the dashboard, we recommend checking the reception of the satellites before
mounting the radio further.
There are two possibilities to see how the reception of the satellites is.
You can use settings – car settings / car infotainment to look at navigation settings which display the
monitor gives.
Another possibility is to swipe between the applications to the app GPS test / GPS fix to see how
many satellites are received.
Not every radio/navigation has a CANBUS decoder.
Depending on model, year of manufacture and/or your car
steering wheel control supported
Mounting of a universal navigation including fitting frame
Before you start reading this page, make sure you have read page 3: ''general tips for installing a car
stereo''.
Before installation
- remove any adapter plugs
- Never press the screen to get the radio in the car
Radio does not automatically turn on/off on contact
If the radio does not turn on, it does not get a power supply, this is because there is no 12 volts
coming in. The red ACC wire is the power wire of the radio, and it must be equipped with contact
power (so that this wire gets power when the ignition is on and does not get a power supply when
the contact is off).