Installation guide

CarShow Installation Guide – Honda CRV
CarShow Copyright 2013 All Rights Reserved
Installation Guide CS-CRV12-3
Page 7
Re-install 2 phillips screws that were removed in
Step 2 to mount OEM hazard switch to CarShow unit.
Be sure to mount included mounting brackets to
CarShow unit
LOCATING REMOTE COMPONENTS
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the vehicle.
And mount the iPod Interface Connector in the vehicle. The following steps will help guide you through
this process.
STEP
4
Use Caution around SRS Components
It is the installer’s responsibility to ensure that the safety
equipment in the vehicle is NOT adversely affected by
installation of this system. Ensure that the routing of the
harnesses do NOT obstruct airbags, SRS or other safety
devices.
Mount the GPS and Sat Radio antenna
on the EXTERIOR of the Vehicle
Route the GPS harness away from other power harnesses
in the vehicle.
This will help to ensure optimum performance of the GPS
system.