Installation guide

CarShow Installation Guide – Honda CRV
CarShow Copyright 2013 All Rights Reserved
Installation Guide CS-CRV12-3
Page 9
INSTALL THE CARSHOW NAVIGATION SYSTEM
You will need to prepare the CarShow Navigation System for installation in the vehicle.
STEP
6
Connect the Power and GPS Harnesses
The GPS Harness must be properly seated into connector.
Also be sure steering wheel control connector is securely
connected.
Failure to follow this step may result in poor GPS signal
and steering wheel controls being inop.
Connect Optional Harnesses such as
Satellite Radio, Camera
These harnesses must be fully engaged prior to the system
installation.
See the Main Harness Diagram below for more information
Turn the vehicle ON and confirm the
unit is fully operational
With the connectors Fully Engaged, turn the vehicle
on and press the RESET located behind SD card
access door.
Insert a DVD to confirm the Video
Disable Circuit is properly Operating.
The wire of the main Honda harness labeled “Brake”
(pink) must be connected to the “Brake” wire (pink) of
the Honda CAN harness.