Installation manual

2.9.1 Remote Controller Buttons
www.car-solutions.com
17
Programming Instructions>
a. Select “POWER” in OSD menu, then press “OK” on
remote controller. (as shown above)
b. If the marked area flickers as shown above, press
“POWER” button on the remote controller of DVD that you
want to use.
c. Programmed values will appear as green text in the
marked area on pressing the button. And the values will
be saved automatically.
d. Program other buttons value in OSD menu according
to the above-mentioned procedure.
>>>
Programming OSD buttons value using remote controller supplied together with DVD,TV,DVB-T.
If you want to control DVD and DMB models other than SANYO and NECVOX via touch screen (using OSD menu, you can
program value of DVD and DMB’ s remote controller which you have. Then you can control DVD and DMB via touch screen.
① First of all, press ◀ button on remote controller for 2
seconds. Enter FACTORY mode, then select IR
MEMORY in UTIL section. There are two options in IR
MEMORY as shown above; DMB and DVD.
Select one of these AV sources.
② This is a window where DVD remote controller button
values are programmed. Just select a menu you want to
save.
(Select “DMB in options of IR MEMORY” if you want to
save values of DMB’ s remote controller. And follow the
instruction below.)
Car Solutions