User guide

S1000-DAB User Guide
c. If the DAB Station List is empty before scanning, and there is no station
detected by DAB Scan, the screen will show 《 DAB; Quick Scan 》. There
are no DAB stations available in the area where you performed DAB Scan
function.
2. To select Manual tune, and start Tuning the DAB Stations
 Press MENU and then keep pressing ◄ or ► until the screen show
《 Manual Tune 》
 Press INFO/ENTER to enter Manual tune selection screen, and it will show
《 Manual Tune ; channel frequency 》where channel frequency is the first
available channel number and its frequency.
 Press ◄ or ►to select the desired channel.
 Press INFO/ENTER to begin the continuous tuning cycle for DAB stations for
the selected channel.
 To exit from the continuous tuning cycle, do the following:
a. Press ◄ or ►to select the next desired channel and press INFO/ENTER to
begin tuning for another channel; or
b. Press INFO/ENTER to stop the tuning and revert to listening to the
currently selected station.
Note:
During tuning for DAB Stations, the first line of the screen will show
《 channel frequency 》where channel frequency is the selected channel and
its frequency, and the second line shows the signal strength.
While selecting the channel, the screen will revert to the station currently
being listened to if you do not press INFO/ENTER within 10 seconds.
It will take a few minutes to perform the tune function; at the end of a tuning
cycle, the display will show the name of detected DAB stations flash across
the top row of the display screen.
To Enable AutoTune
If your car radio is not RDS compatible or does not have AF feature then please refer
to the section To Enable AutoScan or To Set the FM Transmitting Frequency Setting
below.
It may become necessary to change the FM transmitting frequency as you drive
into
an area where the FM frequency transmitted by S1000-DAB is used by an FM
broadcaster. S1000-DAB has an AutoTune function that allows you to continuously
listen to DAB programs through your car radio system without the need to change the
FM frequency manually. (Subject to car radio compatibility)
To perform this AutoTune function, your car radio must be RDS compatible, has the AF
(Alternative Frequency) feature and the AF feature of your car radio must be activated.
When the AutoTune function of S1000-DAB is enabled and the AF feature of your car
12