User guide

S1000-DAB User Guide

To Enable AutoScan

If your car radio is not RDS compatible or does not have AF feature, you must not

enable AutoTune. However, you can use AutoScan to automatically search for unused

FM frequency for transmitting. When this function is activated, the S1000-DAB will

keep searching available FM frequencies, and display these frequencies whenever you

need. You may select one of them as the new transmitting frequency and tune your car

radio in this new FM frequency to receive DAB services continuously.

Setting on S1000-DAB

 Press MENU and then press ◄ or ► until the screen shows《 System Setup 》.

 Press INFO/ENTER, and then press ◄ or ► until the screen shows 《 FMTX

Mode 》.

 Press INFO/ENTER, and then press ◄ or ► until the screen shows 《 FMTX

AutoScan 》.

 Press INFO/ENTER, the function of AutoScan is now enabled and the

S1000-DAB is operating in the AutoScan mode.

 Press FM and the screen will show the current FM transmitting frequency, make

a note of that number.

Setting on Car Radio

 Tune the car radio to the same FM frequency that matches with S1000DAB’s

current FM transmitting frequency.

Note:

If this is the first time you use the S1000-DAB In-Car Digital Radio Adaptor, it

is necessary to perform a Scan function as described in section To Scan the

DAB Stations.

While in the AutoScan mode, S1000-DAB will automatically search for three unused

FM frequencies and save them into the memory in sequence (from frequency 1 to

frequency 3). When you are using S1000-DAB to listen to a DAB service and

experience interference from other source, which means that you are driving into an

area where the present FM frequency is used by an FM broadcaster. When this

happens, you need to find an unused FM frequency for transmitting the DAB service to

your car radio. The enabled AutoScan feature can help you to do such change quickly

by the following steps:

Operating on S1000-DAB

 Press FM and the screen will show the current FM Transmitting Frequency.

 Keep pressing FM, and it cycles thru from frequency 1 to frequency 3 for each

time your press. Stay at the frequency you like, which will be the new FM

frequency for transmitting.

 Press INFO/ENTER to confirm, and the screen will show 《 Re-tune to ;