User guide

S1000-DAB User Guide

transmit FM signal at the new frequency. Now you can listen to DAB stations via

this FM Frequency.

To Set the FM Transmitting Power Level

While listening to the DAB program, if you experience interference and noise, you

may adjust the FM Transmitting Power Level to increase the power of FM signal

transmission to suppress the interference.

 Press MENU and then ◄ or ► until the screen shows《 System Setup 》.

 Press INFO/ENTER, and then press ◄ or ► until the screen shows

《 FMTX Power 》

 Press INFO/ENTER to enter power level selection screen.

 Then you can press ◄ or ► to step up or down power level bar.

《■■■■■■■□□□□□□□□□》

 Finally, press INFO/ENTER to set this power level

Note:

The default is power level 8.

To Prune the Unavailable Stations

As you drive into a new area, some of the existing stations may become unavailable

since the reception is out of the DAB broadcaster range. These stations are

displayed as 《 Station list ; ?station name 》You can remove these unavailable

stations by using this function.

 Press MENU and then press ◄ or ► until the screen shows《 Prune 》.

 Press INFO/ENTER to perform a prune operation. The screen will show

《 Prune? ; <No> Yes 》.

 If you do want to prune, press ◄ or ► to find the 《 Prune? ; No <Yes> 》 and

press INFO/ENTER to prune. Otherwise, you can press INFO/ENTER to cancel

while the screen is showing 《 Prune? ; <No> Yes 》.

Note:

All unavailable DAB Station will prune, including all memory presets, for all

DAB Presets of the system. 《No Name》will be showed on the Screen.