Assembly Manual

Feed the free end of the belt into a belt clip. For the
bottom portion of the belt, pull through enough so
that a  (6mm) gap eists beteen the Y-Ais
Right Carriage and the belt clip as shon in the
image belo.
nsert a M510mm scre through the Y-Ais Right
Carriage and into the belt clip. Tighten don as
shon in the image belo. The belt should be tight
enough to snap against the X-Ais Rail hen gentl
lifted, but do not oer-tighten as this could bend
and damage the X-Ais Motor Pulle.