Assembly Manual

With the scres loosened, slide the bracket
beteen the scre heads and the plate as shon
belo. Re-tighten both scres to secure the X-Ais
Drag Chain Bracket in place.
nstalling the Y-Ais Drag Chain
Bracket
Remoe the to top scres holding the motor to
the Left Y-Ais Plate as shon belo.
NOE: The Y-Ais Plate ships ith shorter
scres holding the motor to accommodate all
three sies of Shapeoko machines. The longer
M516mm scres for the XXL are needed to
attach the remaining Drag Chain Bracket. The
M516mm scres can be found in the bag
labeled Drag Chain Bracket.