Assembly Manual

Locate the end of the Y-Ais Wiring Harness ith
the labeled female connectors, as shon in the
photo belo.
The Drag Chains ill onl roll/curl in one direction.
t is important to look at the photos and make sure
ou are connecting the correct ends to the correct
locations. Do not connect the ires to the
Controller Board at this time.
Attach the Y-Ais Drag Chain
Use to (2) M312mm athead scres and to
(2) M3 nlon nuts to attach the Drag Chain to the
Y-Ais Drag Chain Bracket as shon belo. The
scres are inserted don through the head of the
Drag Chain and through the slot in the Y-Ais Drag
Chain Bracket.