Assembly Manual

one for the Z ais. Each limit sitch is attached to a
tisted-ire pair of black and ello ires.
The sitches are pre-installed to their respectie
plates during the harness assembl in the factor.
n this step e ill connect those plates to their
permanent locations on the machine.
Z-Ais Limit Sitch
Attach the Z-Ais Limit Sitch b locating the larger
plate from the end of the harness and connecting
to the front of the X/Z assembl. This plate is isible
in the image belo.
You ma need to adjust our iring from the
harness at this point. The iring is ip tied
together, but is not bound to the drag chains.
Gentl pulling on the ires for more length is
acceptable.
NOE: f the ires ou are attempting to pull
do not slide freel, make sure the are not
snagged at the other end of the drag chain.