Assembly Manual

The Z-Ais homing sitch plate attaches to the
front of the X/Z assembl using four (4) M510mm
button head cap scres.
Make sure the limit sitch is located in the bottom
left corner of the plate (hen ieed from the
front of the Shapeoko XXL) before securing to the
standos. You can identif the location of the
sitch b looking for the small he nut on the
outside of the plate.
NOE: Depending on ho our harness as
pre-assembled and hether an shifting
occurred during shipment, it ma be necessar
to clip the top ip-tie to allo for more of the
black-and-ello tisted ire to be pulled
through the Drag Chain.