Assembly Manual

Use the adhesie tie don on the back of the X-Ais
motor to secure the poer cord.
Route the poer cable back to the right side of the
Shapeoko XXL and through the slot in the Y-Right
carriage.
Tension the V-Wheels
Once the carriage is on the rail, support the right
end ith another 974 bo and center the
carriage on the rail.
Using the M8 (or 5/16) rench, turn the eccentric
nuts clockise until the heels engage ith the
rail. The eccentric nuts should be in the position
shon in the folloing image.