Assembly Manual
Once the idler assembl is through the slot, loosel
attach the nut on the backside of the plate. Some
adjustabilit ill be required to get the belt in
place, so leae this lightl nger tight for the time
being.
nstall Spindle Mount
Align the spindle mount ith the bottom set of
through holes on the -carriage. The carbide logo
should go right side up, but the position of the
pocketed hole on the spindle mount does not
matter (left or right is ne).
The ed pulle location hold be on the left side
of the plate, as shon in the photo. For further
reference: the eccentric nuts ill be on the left side
as ell.