Instructions
away from the centers of the Cross Straps and the
MDF Baseplate is ush with the edges of the Cross
Straps. (This should reveal three holes running
across the middles of the Cross Straps that will be
used for the second MDF Baseplate.)
Insert 3x M5x25mm screws into the three
countersunk holes as shown in the gure below.
Turn the screws until they stop but do not tighten.
PROTIP: Some adjustability will be needed
when installing the Y-axis rails. If you fully
tighten the baseplate, the Y-axis rails will be
dicult to install.