Instructions

Install the X-Axis Drag Chain Bracket by loosening
the two rear screws on the top of the X plate as
shown in the gure below.
Note that when looking from the front of the
Shapeoko XXL, the two screws are on the right side.
The screws only need to be loosened enough to
slip the bracket between the screw heads and the
plate. Because thread lock is used at the factory to
secure the connection, using a pair of pliers (not
provided) to grip the stando, may be necessary.
With the screws loosened, slide the bracket
between the screw heads and the plate as shown
below. Re-tighten both screws to secure the X-Axis
Drag Chain Bracket in place.