User Manual

– 3 –

No access point associated

with the card.

Card attempting to associate

with an access point.

Card exchanged data with an

access point. The higher the

data rate, the faster the

blinking.

Removing the PC Card

Use the release lever or button your card slot to free the PC Card (Figure 3).

Pull on the sides of the card to remove it from the slot. Do not pull on the antenna.

CAUTION: The antenna on the PC Card is not removable. Trying to remove the card by

pulling on the antenna can break the antenna, causing permanent damage to the card.

Installing the Documentation

More detailed installation procedures can be found in the Network Interface Card User

Guide.

Put the End User Utilities CD in the CD-ROM drive. The Setup program will start

automatically.

If the Setup program does not start, use Start/Run to run the SETUP.EXE program from the

CD-ROM drive.

Select Documentation.

You can view the manuals from the CD.

Select Install User Documentation to install the manuals on your hard disk.

Follow the instructions on the screen to complete the installation.

Exit the setup program.

You can open the manuals from the Card Access program group.

Product Registration and Support

To register this product with Card Access Corporation, go to the following Web page:

http://www.insertwebaddresshere.com

For support information and pointers to the latest drivers and utilities available for the

Card Access network interface card, go to the following Web page:

http://support.insertwebaddresshere.com