Installation Guide
Figure 3 - Mounting the Fan
Adjusting the Solar Panel
The solar panel on your Cardinal Ventilation solar attic fan may
either be left down in the horizontal mounted position as received
from the factory, or the solar panel bracket may be raised to tilt
the solar panel toward the south for better sun exposure.
To raise the solar panel, first loosen the set bolts on the solar panel
mounting brackets using a 7/16" wrench as shown in Figure 4.
Raise the solar panel to the desired tilt angle using the provided
adjustment slots and tighten the set bolts.
LOOSEN SET BOLTS
RAISE SOLAR PANEL
Figure 4 - Adjusting the Solar Panel
Warranty Registration
Cardinal Ventilation oers an industry leading 25-year standard parts warranty on your new solar attic fan.
For more information about the terms and conditions of our warranty, please see our website for details.
YOUR WARRANTY MUST BE REGISTERED WITHIN 90 DAYS OF INSTALLATION. Please visit our
website at www.cardinalventilation.com to register your warranty.
www.cardinalventilation.com
DO NOT OVER TIGHTEN THE SET BOLTS! You may
damage your bracket if too much torque is applied to the
set bolts.
ATTENTION: Do not raise the solar panel if installing this
product in an area of either Florida or Texas that has been
designated as a high velocity wind zone area. The solar
panel must remain in the flat horizontal position due to
building code requirements.
Cardinal Ventilation Installation Guide.indd 4 6/18/2018 3:54:12 PM