Instruction manual

Cardio Theater Instruction Manual
.
.
12
LCS-TX — 4 Channel Transmitter
Setup
Programming LCS-TX — 4 Channel Transmitter
NOTE:
These instructions are for LCS Transmitters with Software version 1.01 and
higher. To determine the software version of your transmitter, power the unit on. The
group number will display for 2 seconds, and then the software version will display for 2
seconds before the unit enters normal operating mode. If the unit does not display this
information, you have a previous version. You should contact the Cardio Theater Service
Center for technical assistance [phone].
Set to U.S. mode:
Press channel down and volume down while powering the unit on — display shows
"1776" until released. Then it displays the software version, then enters normal operation
showing the group # on the left side of the display and the channel # on the right.
Set to Australian mode (if using in Australia only):
Press channel up and volume up while powering the unit on — display shows "1901"
until released. Then it displays the software version, then enters normal operation
showing the group # on the left side of the display and the channel # on the right.
Setting the Group:
Press volume up and volume down while powering the unit on — Display shows "01".
Release volume up and volume down buttons. Use the channel select buttons to scroll to
the desired group (1-13). Press volume down to lock the group into memory. Display will
http://www.cardiotheater.com/inst_manual.html (18 of 30) [4/13/2004 7:35:45 AM]