INSTRUCTION MANUAL xTV9T4 – 900 Mhz 4 Channel Transmitter xTV9R Receiver Cardio Theatre Holdings, Inc. 20031 142nd Ave NE P.O. Box 7202 Woodinville, WA 98072-4002 (800) 776-6695 (425) 486-9292 www.cardiotheater.
Introduction CONGRATULATIONS on your choice of this product. Its superior sound reproduction will provide enjoyment and entertainment. We appreciate your patronage and take pride in the quality components our company produces. Please read this manual before you install and operate the system. This manual will acquaint you with operating features and system-connection considerations. Retain this manual for future reference.
FCC Compliance Statement NOTE: This equipment has been tested and found to comply with the limits for Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Before You Begin • Please ensure that you have all of the required equipment before disposing of any packing materials.
Important Safeguards Please read all of the safeguards before operating this unit. Follow all warnings placed on the unit and adhere to the operating and use instructions. Retain this manual for future reference. 7. Heat - The unit should be located away from heat sources such as radiators, heat registers, stoves, etc. 1. Power sources - Connect the unit to a power source only of the type described in the operating instructions or as marked on the appliance. 2.
Important Safeguards - Continued 12. Stands - Any component stand should be moved with care. Quick or excessive force would cause the stand to overturn 14. Damage requiring service – The unit should be serviced by a qualified Cardio Theater technician when: A. The power cord or the plug has been damaged. B. Objects have fallen on, or liquid has been spilled into the unit. C. The unit does not appear to operate normally or exhibits a marked change in performance. D.
Suggestions for Installation General Information • Group the audio components in a single location to minimize cabling in the cardiovascular room. • If the audio components are stacked in a stereo cabinet, ensure there is adequate ventilation. • Place the xTV9T4 transmitter in a well-ventilated area with the front and back easily accessible. • Place the transmitter antenna eight to twelve feet (8’-12’) from the floor to obtain the best possible transmission range.
Controls and Indicators xTV9T4 Transmitter - Front 1. 2. 3. 4. 5. 6. 7. Transmitter Select – Used to select transmitter output, 1-4 (program mode only). Input Signal – For viewing audio input levels. Power-on Indicator - Lights when main power switch is on. On / Off Switch – Turns power on or off to transmitter Transmitter indicator- Displays current transmitter selected for adjustment (program mode only). Channel Indicator - Indicates current channel Volume Indicator – Indicates volume level selected.
Controls and Indicators xTV9 Receiver 1. 2. 3. 4. 5. Channel Display - Indicates current channel selected. Channel Select - To select the desired listening channel. EQ Tone - Adjusts audio to predefined EQ settings Volume Adjust - To select desired listening volume. Mute/Programming - Audio mute. Also used for putting unit into program mode.
System Connections Transmitters NOTE: MAKE ALL CONNECTIONS TO THE TRANSMITTER AND RECEIVERS WITH POWER OFF. Step 1 Connect the antenna to the antenna connector on the back of the xTV9T4 transmitter. Step 2 Connect up to four (4) audio components to the stereo input jacks on the back of the xTV9T4 transmitter. Step 3 Use the power cord supplied to connect the transmitter to AC power.
System Connections, Transmitter/TV Setup 10
System Connections, Transmitter/Satellite Setup 11
Attaching xTV Receivers The xTV Receiver can be attached to virtually any piece of equipment. • Attach the supplied coiled control cable into the RJ45 telephone connector on the back of the receiver, as shown below. Be careful to push the rubber boot firmly into the recess to form a tight seal around the connector. Failure to do this may void your warranty. • Attach the supplied neoprene mounting pad to desired location on the exercise equipment.
xTV9T4 Transmitter Setup NORMAL OPERATION There are four modes that the transmitter can be in: xTV US/Canada xTV Australia 32 possible frequencies 16 possible frequencies LCS US/Canada LCS Australia 52 possible frequencies 24 possible frequencies Upon power up, the display will show '88.88' briefly as a lamp test, then display briefly one of the four shown below to indicate which of the four modes the transmitter is in: xTV US/Canada xTV Australia '07.76' '09.01' LCS US/Canada LCS Australia '17.
xTV9T4 Transmitter Frequency Chart Cardio - United States Cardio - Australia xTV - United States xTV - Australia Frequency Channel Frequency Channel Frequency Channel Frequency Channel 01 02 03 04 05 06 07 08 09 10 11 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 916.2 917.4 918.0 919.4 920.2 922.4 924.0 925.0 922.0 923.6 926.2 920.6 921.6 923.2 925.8 915.8 917.0 918.4 919.8 919.0 921.0 922.8 925.
Programming the Receiver The procedure outlined below must be followed, to set up your receivers for first time use or anytime a receiver is replaced. Make sure that all transmitters that will used in the Club are on and operating before going through the programming procedures below. Note: Make sure that you program the receivers in the same mode that the transmitters are set on. Auto Program Mode: 1.
Receiver Maintenance Replacing a worn Headphone Jack Assembly Remove receiver from the cardio equipment. On the back of the receiver remove the two inner screws on the bottom of the receiver as shown below. This will release the worn headphone jack assembly from the receiver. Turn receiver over, remove the worn headphone jack assembly and discard. Replace it with a new assembly.
Specifications xTV9T4 –Transmitter Transmission bandwidth....................……….... 902 MHz to 928 MHz Frequency Range......................................…….. adjustable from 905.4 MHz to 926.2 MHz. Available Channels……………………….…….... 32 channels xTV mode, 52 Cardio LCS mode Transmission Power.................................…….. 95 dbmv max. Transmission Range.................................…….. 150 ft. from antenna Power Consumption.................................…….. 25 watts max. Audio Inputs.......
Limited Warranty PLEASE READ THESE WARRANTY TERMS AND CONDITIONS CAREFULLY BEFORE USING YOUR CARDIO THEATER PRODUCT. BY USING THE EQUIPMENT, YOU ARE CONSENTING TO BE BOUND BY THE FOLLOWING WARRANTY TERMS AND CONDITIONS. Limited Warranty. Precor Incorporated (“Precor”) warrants all new Cardio Theater products to be free from defects in materials and manufacture for the warranty periods set forth below. The warranty periods commence on the invoice date of the original purchase.
Technical Support Technical Support Number Telephone 1-800-776-6695 Technical Support Hours: 7:00 AM to 3:30 PM Monday through Friday PST Write to: Cardio Theatre Holdings, Inc. 20031 142nd Ave. NE Woodinville, WA 98072-4002 Notice Due to continuing advancements in technology, Cardio Theatre Holding, Inc. reserves the right to make changes in hardware, packaging, and any accompanying documentation without prior written notice.