Instruction manual

12
Attaching xTV Receivers
The xTV Receiver can be attached to virtually any piece of equipment.
• Attach the supplied coiled control cable into the RJ45 telephone connector on the back of the receiver, as
shown below. Be careful to push the rubber boot firmly into the recess to form a tight seal around the
connector. Failure to do this may void your warranty.
• Attach the supplied neoprene mounting pad to desired location on the exercise equipment.
• Align the xTV Receiver over the mounting pad on the handle or rail.
• Use two of the supplied plastic wire ties to attach the xTV Receiver to the handle or rail. Pull wire ties firmly to
secure and cut off the excess.
This method may be used to mount an xTV Receiver either horizontally or vertically.