User's Manual
Page11of17
TECHNICAL SPECIFICATIONS
CONNECTI ONS
Base Power in (15V, 1.2A max); Phone in (RJ-11); Phone out (RJ-11)
Monitor Power in (15V, 1.2A max)
Wall Adaptor Power in (100-240 VAC); Power out (15V, 1A or 15V, 1.67A)
STANDARDS COMPLI ANCE
Monitor EN60601-1; AAMI EC-38; FCC Part 15
Sensor EN60601-1; AAMI EC-38; FCC Part 15
Base EN60950; FCC Part 15, 68
AECG Equipment Type I
Note: This equipment has been tested and found to comply with the limits for medical devices to the
IEC 60601-1-2:2001, Medical Device Directive 93/ 42/ EEC or the Electromagnetic Compatibility
Directive 89/ 336/ EEC (use applicable directive). These limits are designed to provide reasonable
protection against harmful interference in a typical medical installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to other devices in the vicinity. However, there is no
guarantee that interference will not occur in a particular installation. I f this equipment does cause
harmful interference to other devices, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures: •
Reorient or relocate the receiving device • Increase the separation between the equipment • Connect
the equipment into an outlet on a circuit different from that to which the other device(s) are
connected • Consult the manufacturer or field service technician for help
EQUIPMENT SYMBOLS