User manual
20 | cardo BK-1
BASIC INTERCOM PAIRING:
1. Check both BK-1 units are in Standby mode (single BLUE ash every 3 seconds).
2. Choose an available channel to pair the rst BK-1 (Channel “A”, “B”, “C” or “D”).
NOTES: • Selecting a Channel that is already in use will override the existing paired cardo BK-1
on that Channel with the newly paired cardo BK-1.
NOTES: • Intercom Conferencing is allowed via Channels “A” and “B” only
3. Enter Intercom Pairing mode by pressing and holding the correct button(s) on the rst BK-1 for at least
5 seconds until the BLUE / RED / PURPLE Light begins ashing rapidly (See table below).
4. Immediately repeat Step 2-3 for the second cardo BK-1. Both units will now be in Intercom Pairing mode.
5. After a few seconds, both units will show a solid light for 2 seconds, indicating that they are now
paired, connected and ready to use.
NOTE: If Pairing is not completed within 2 minutes, the cardo BK-1 will return to Standby mode.
INTERCOM CHANNEL PAIRING / CALLING BUTTON(S) PAIRING MODE LED INDICATORS
Channel “A” Rapid RED ashing
Channel “B” Rapid BLUE ashing
Channel “C” and Rapid PURPLE ashing
Channel “D” and Rapid PURPLE ashing
5.1b. THREEWAY INTERCOM
If you have purchased the cardo BK-1 DUO, both units are factory-paired and congured to communicate via their
respective Channel “A” Buttons. To pair a third cardo BK-1 use Channel “B”.
To set up three-way intercom conference mode for conference calls with Channel “A” and Channel “B”
only proceed as follows:
Cyclist “1” is paired to Cyclist “2” and Cyclist “3”