User manual
ENGLISH
cardo BK-1 | 25
6.2. MUSIC STREAMING A2DP
6.2a. PAIRING TO AN A2DP MUSIC PLAYER
• Listen to stereo music via A2DP (non-mobile phone device)
NOTE: The cardo BK-1 can also receive audio via the enclosed cable from non-Bluetooth MP3 Players or audio sources
as described in section 6.3.
1. Turn on the music player and make sure that Bluetooth function is activated.
2. Check the cardo BK-1 is in Standby (single BLUE ash every 3 seconds).
3. Press for at least 6 seconds. The BK-1 will rst ash RED. Continue to hold the button until the RED
and BLUE lights begin rapidly alternating.
4. Search for Bluetooth device on the music player by following the device’s instructions.
5. Once your music player lists the “cardo BK-1” as a discovered device, select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. The music player may conrm that pairing has succeeded, and the cardo BK-1 will begin ashing
slowly in BLUE.
NOTE: If Pairing is not completed within 2 minutes, the cardo BK-1 will return to Standby mode.
6.2b. LISTENING TO MUSIC: A2DP BLUETOOTH AUDIO SOURCES
BASIC FUNCTIONS Available only on AVRCP compatible Bluetooth audio sources
Play
Press for 2 seconds
Pause/Stop
Press for 2 seconds
Forward
Press for 2 seconds
Rewind*
Press for 2 seconds
*With some phones you may need to repeat this action
SWITCHING BETWEEN A2DP AUDIO SOURCES
If a music player is paired, the cardo BK-1 will use it as the default A2DP audio source.
1. Stop the music playback from the current device.
2. Start music playback from the other device.