User manual

26 | cardo BK-1
6.3. CABLECONNECTED MP3 PLAYERS
The Multi-Port may be used to connect a non-Bluetooth audio source with a 3.5 mm–⁄” stereo jack
using the enclosed cable.
Multi-Port
(Charging / Software Upgrade / Aux Line-in)
1. Check the cardo BK-1 is in Standby (single BLUE ash every 3 seconds).
2. Connect the MP3 cable to the busic player’s jack and insert the other end of the cable into the Multi-Port.
To listen to music from a cable-connected device, operate the music player using its buttons as usual
(FF/REW/ PLAY/PAUSE).
NOTE: While listening to audio from the Multi-Port, the VOX feature is disabled.
7. TROUBLESHOOTING
Reboot
If your BK-1 stops responding, reset it by turning it o and then on again (press for 2 seconds ) .
Reset Pairing
(Deletes all paired
devices)
1. In Standby, press for 6 secs until LED ashes RED/BLUE.
2. Press for 2 seconds until LED ashes 5 times in PURPLE.
8. SUPPORT
For additional information:

www.cardosystems.com

[e-mail]

USA and Canada: 1-800-488-0363 International: [phone]
IMPORTANT
MULTINATIONAL COMMERCE COMPANIES AND ONLINE AUCTION WEBSITES ARE NOT AUTHORIZED TO SELL CARDO PRODUCTS AND PURCHASES FROM SUCH SITES ARE
AT YOUR OWN RISK. TO RECEIVE WARRANTY OR CUSTOMER SERVICE, YOU MUST SUBMIT ORIGINAL RECEIPTS FROM AUTHORIZED CARDO DEALERS.
PRODUCTS THAT WERE IMPORTED FROM NORTH AMERICA MUST BE SERVICED IN THE USA.