User's Manual

3
English
Cardo Rider Q2™ |
Wall Charger
Allen Wrench
Velcro Pads
Extension Pad
User Guide, including Warranty and Registration form
IMPORTANT:
The Cardo Rider Q2 is a water-resistant device, designed for use
under moderate rain or snow conditions. However, the headset is not
waterproof and should not be used under severe weather conditions.
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
BEFORE USING (CHARGING THE
HEADSET)
Make sure that the headset is fully charged for at least ve hours before
initial use.
1. Connect the wall charger to the headset’s Charging Jack
(located between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to
15 seconds until the Red Light turns on). When charging is
complete, the Red Light will turn o.
Tab
Sliding Plate
Microphone
Right Speaker
(long cord)
Left Speaker
(short cord)
CONTENTS OF RETAIL BOX | BEFORE USING |
SET UP AND CONFIGURATION
STEP 1
SET UP FOR BIKE-TO-BIKE INTERCOM: PAIRING
The Cardo Rider Q2 can be paired with up to two other headsets for
Intercom communication, referred to in this guide as:
Primary Buddy
and
Secondary Buddy.
Pairing is a one time process. Once the headsets are paired during
this Setup Procedure, they will remain paired and automatically
recognize each other whenever they are within range.
NOTE: The Cardo Rider Q2 allows you to speak via Intercom to one Buddy
headset at a time.
Cardo Rider Q2 or
scala-rider
Family Headset
Mobile Phone
GPS
200 meters
(600 ft.)
Embedded
FM Radio
Embedded
FM Radio
Full Duplex
Intercom
Connection
200 meters
(600 ft.)