User's Manual

4
| Cardo Rider Q2
™
PRIMARY BUDDY PAIRING (requires two Cardo Rider
Q2 headsets)
1. If either headset is turned OFF, turn it ON by pressing and holding
the CTRL Button until the Blue Light ashes three times.
2. Make sure that both headsets are now ashing slowly in Blue.
3. Pick up one headset and simultaneously press and hold the CTRL
Button and MC Button for at least six seconds until the Red Light
begins ashing rapidly, indicating it is in Intercom Pairing mode.
4. Repeat Step 3 again for the second Cardo Rider Q2 headset. Both
headsets should now be ashing rapidly in Red.
5. Within a few seconds, both headsets will show a solid Red light for
two seconds, and then begin ashing slowly in Blue.
SECONDARY BUDDY PAIRING (requires three Cardo
Rider Q2 headsets)
Once you have paired the Main Cardo Rider Q2 to the Primary
Buddy headset, repeat the procedure above to pair the Main
Cardo Rider Q2 to the Secondary Buddy headset.
NOTE: The Main Cardo Rider Q2 is able to communicate with either
the Primary Buddy or the Secondary Buddy. The Primary Buddy and
Secondary Buddy are not able to communicate directly via Intercom.
NOTE: If the Pairing process is not completed within one
minute the headset will return to Standby mode.
STEP 2 (Optional)
SET UP FOR RIDER-TO-PASSENGER INTERCOM: PAIRING
There are two ways that the Cardo Rider Q2 can be used for Rider-to-
Passenger communication.
| SETUP AND CONFIGURATION
A. Both Rider and Passenger are using Cardo Rider Q2 headsets.
To Pair the two headsets, follow the Steps listed in the section above
titled PRIMARY BUDDY PAIRING.
B. The Rider is using a Cardo Rider Q2 and the Passenger is using a
scala-rider headset (i.e. a scala-rider, a scala-rider FM or a scala-
rider TeamSet Driver unit headset).
To Pair the two headsets:
1. Starting with the scala-rider headset turned OFF, press and
hold the CTRL button until the Red/Blue lights begin rapidly
alternating.
2. Starting with the Cardo Rider Q2 turned ON, simultaneously press
and hold the CTRL Button and MC Button for six seconds until the
Red light begins ashing rapidly, indicating it is in Intercom Pairing
mode.
3. Within a few seconds, the Cardo Rider Q2 will show a solid Red
light for two seconds, and then begin ashing slowly in Blue.
NOTE: If the Pairing process is not completed within one minute the
headset will return to Standby mode.
NOTE: When using a scala-rider headset as a Passenger headset, Voice
Connect Intercom can be initiated only by the Cardo Rider Q2 headset.
Manual Connect Intercom can be initiated from either headset.
RESET INTERCOM PAIRING
You can delete all of the headset’s Intercom pairings at any time.
1. Place the Cardo Rider Q2 into Intercom Pairing mode following the
instructions in the PRIMARY BUDDY PAIRING section above.
2. Once the Red Light begins ashing rapidly, press and hold Volume up
for three seconds.
3. The Red and Blue Lights will ash ve times, conrming that the Reset
Pairing was successful.