User's Manual

6
| Cardo Rider Q2
™
mobile phone to your GPS device by following your GPS and/or
mobile phone’s instructions.
NOTE: If the Pairing process is not completed within two minutes
the headset will return to Standby mode.
MOUNTING THE HEADSET ON THE HELMET
The microphone/speaker clamp must be
mounted onto the helmet. Once mounted,
the headset unit can be attached or
detached from the microphone/speaker
clamp at any time.
Attaching the Clamp to the Helmet
1. Use the enclosed Allen Wrench to loosen
the two screws on the Back Plate.
2. Slide the Back Plate between the internal
padding and the external shell of the
helmet. (If the external shell is too thick, use
the supplied plastic Extension Pad by loosening the screws and
tting the Extension Pad between the Back Plate and the main
body of the clamp.)
3. Adjust the clamp’s location so that
the microphone is located in front of
the center of your mouth, with the
yellow sticker pointing towards your
mouth, and then tighten the screws.
ATTACHING AND REMOVING THE HEADSET FROM THE
HELMET CLAMP
ATTACHING:
Slide the headset downwards along
the sliding panel until a clicking sound
indicates that the headset is locked in place.
| SETUP AND CONFIGURATION
REMOVING:
Your headset can be removed for
charging and storage by pressing
your nger gently against the tab and
sliding the headset up with the other
hand.
We recommend that you remove the headset from the helmet when not
in use.
SPEAKERS AND MICROPHONE POSITIONING
The microphone must be positioned vertically, not horizontally, in
front of the center of the mouth, with the yellow sticker pointing
towards the mouth.
Attach the speakers to the Velcro inside your helmet opposite your ears
(short speaker cord for left ear & long speaker cord for right ear), or use
the supplied Velcro pads.
USING THE HEADSET
GENERAL USAGE
GENERAL FUNCTIONS
DESIRED RESULT: REQUIRED ACTION:
Turn on the headset Press the CTRL Button steadily for at least three seconds
Turn o the headset Press the CTRL Button steadily for at least three seconds
Increase the volume Short press the Volume Up Button
Decrease the
volume
Short press the Volume Down Button
AGC (Automatic Gain Control): In addition to manual Volume Control,
the Cardo Rider Q2 will automatically increase and reduce its volume
according to ambient noise and driving speed.
CORRECT INCORRECT
Allen
Wrench
Back
Plate
Press here to remove