User's Manual
7
English
Cardo Rider Q2™ |
AUDIO SOURCES AND PRIORITIES
The dierent Audio Sources that are connected to the Cardo Rider Q2 are
prioritized as follows:
Highest 1. Mobile phone Audio / GPS device (Incoming/outgoing calls ,
GPS audio and navigation instructions)
2. Primary Buddy Audio and Secondary Buddy Audio
Lowest 3. FM Radio
A high priority Audio Source will always interrupt any lower priority Audio
Source.
i.e. Mobile phone call interrupts Intercom call
Intercom call interrupts FM Radio
USING THE INTERCOM
Making Intercom calls
To start a Buddy Intercom call with the Primary Buddy while the
headset is on Standby you can either:
VOICE CONNECT:
Start talking
A Buddy Intercom call will be
established and stay on until
both sides are quiet for 30
seconds.
MC BUTTON CONNECT:
Single tap the MC Button
A Buddy Intercom call will be
established. To end the Buddy
Intercom call, single tap the
MC Button again.
To start a Buddy Intercom call with the Secondary Buddy while the
headset is on Standby:
MC BUTTON CONNECT:
Double tap the MC Button
A Buddy Intercom call will be established. To end the
Buddy Intercom call, double tap the MC Button again.
SETUP AND CONFIGURATION |
NOTE: When using a scala-rider Headset as a Passenger headset, Voice
Connect Intercom can be initiated only by the Cardo Rider Q2 headset.
Manual Connect Intercom can be initiated from either headset.
Failed Connection: On the Cardo Rider Q2, if you attempt to start
a Buddy Intercom call with a Buddy that is already on a Phone/GPS/
Intercom call, you will hear a double beep indicating the Buddy is busy.
Reconnecting the Intercom: If the Cardo Rider Q2 and its Intercom
Buddy headset go out of range and disconnect from each other, the
Cardo Rider Q2 will automatically try to reconnect to its Intercom Buddy
for ve minutes.
You can manually reconnect at any time by pressing the MC Button
(single tap for Primary Buddy and double tap for Secondary Buddy).
Receiving Intercom calls
If you are not speaking with any one, once the other party tries to initiate
a Buddy Intercom call, the call will begin immediately.
TROUBLESHOOTING THE INTERCOM:
First, make sure your microphone is located properly in front of
the center of your mouth.
The Cardo Rider Q2 is designed for use in loud environments.
Please make sure to test the Intercom functionality in a LOUD
environment, such as next to an idling motorcycle.
Please also verify that the headsets were paired together properly
by following the instructions in the relevant Setup sections.
Setting Voice Connect Intercom preference (Primary vs. Secondary
Buddy)
The headset’s Voice Connect feature allows you to start a Buddy
Intercom call by simply speaking into the microphone. You can dene
MC Button
or