User's Manual

9
English
Cardo Rider Q2™ |
on the radio. The radio tunes in to the last radio station you were listening
to. With some phones you should wait a few seconds after ending a call
before turning on the Radio.
Turning the FM Radio O
While the radio is turned on, press and hold the MC button for three
seconds to turn the Radio o.
Switching Preset FM Radio Station
There are six pre-set Radio stations available on your Cardo Rider Q2.
While the Radio is on, tap the MC Button to cycle between saved stations.
Searching for a New FM Radio Station
While the Radio is on, press and hold the Volume Up or Volume Down
Button for three seconds or until you hear the next station on your
headset.
Pressing Volume Up will search upwards (higher frequency). Pressing
Volume Down will search downwards (lower frequency). Once a station is
found, searching stops and you can hear the station.
To save this station, refer to the following section.
To continue searching, press the Volume Up or Volume Down Button
again for three seconds.
You may still continue to listen to the current unsaved station. Pressing
the MC Button in this case will switch to the next saved station.
Saving an FM Radio Station
The FM Radio is equipped with a memory capacity of six stations.
• Select the station you wish to replace by tapping the MC button
until you nd the station you want to replace.
• Search for a new station as described above.
• Tap the MC Button within 20 seconds of nding the station to save
the current station.
SETUP AND CONFIGURATION | SUPPORT | NOTICES
If you don't save the station, the Radio will exit search mode without
saving the current station. You can still continue to listen to the current
unsaved station. Tapping the MC Button in this case will move to the next
saved station.
SUPPORT
For additional information please visit our website at
www.cardosystems.com
FAQ: www.cardosystems.com/faq
or contact us at:
[e-mail]
Phone:
USA and Canada – + 1-800-488-0363
International – [phone]
NOTICES
FCC Notice
This equipment complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for

instructions for satisfying RF exposure compliance. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.