User Manual

PAGE 17 / 28
Section 9.3 explains how to pair your G4 with earlier, non-G4 scala rider models, such as the
“Q2
TM ”, "Solo TM ", the "FM TM ", or a "TeamSet TM " Driver unit.
Initiate Intercom calls
There are two ways to start an
Intercom
call with your paired headsets while the headset is in
Standby mode:
VOICE CONNECT
:
Start talking loudly
Once you start talking loudly, an Intercom call will be
established with both paired headsets, CHANNEL A and
CHANNEL B (if both are available).
The Intercom call will stay on until all participants remain
silent for 30 seconds.
CHANNEL BUTTON CONNECT
:
Single tap the CHANNEL A Button to add or
remove the CHANNEL A headset from an
Intercom call.
Single tap the CHANNEL B Button to add or
remove the CHANNEL B headset from an
intercom call.
Receiving Intercom calls
Once another paired headset tries to initiate an Intercom call with your headset, the call will begin
almost instantly.
NOTE: You cannot
receive Intercom calls while you are receiving voice instructions from your GPS,
listening to a Bluetooth Stereo A2DP source, or while you are on an active phone call. In such case
the caller will hear a busy signal and you will hear two beeps, indicating that an intercom caller is
trying to page you. (see section 5c for details on audio priorities of paired devices).
Enable/Disable Voice Connect feature
Press and hold the Volume Up and Volume Down Buttons simultaneously for three seconds until you
hear a beep. The default status is Voice Connect enabled.
NOTE: The Enable/Disable Voice Connect feature affects only the Intercom functionality.
RESET PAIRING (restoring the original default configuration)
You can delete all of the headset’s paired units at any time as follows:
1. With the scala rider G4 headset turned ON, press and hold the Mobile Button
for at least six
seconds until the Red and Blue Lights begin rapidly alternating.
2. Press and hold the Volume Up button for three seconds.
3. The Red and Blue Lights will flash five times and then the headset will turn off, confirming that
Reset was successfully completed.
NOTEWORTHY RULES AND EXCEPTIONS
1. Connecting your G4 to non-G4 units
To pair your G4 to earlier scala rider models, please refer to section 9.3 below.