User Manual

PAGE 19 / 28
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an Intercom call will
be established with the other paired headset.
The Intercom call will stay on until all participants
remain silent for 30 seconds.
CHANNEL BUTTON CONNECT:
Single tap the correct CHANNEL Button to
add or remove the other headset from an
Intercom call.
b. THREE-WAY INTERCOM
The scala rider G4 offers three-way intercom conference connectivity as follows:
In this configuration Rider B
is paired to Rider A and to Rider C.
IMPORTANT: Since Rider B uses two Bluetooth
connections during the conference mode, Rider’s
headset will be disconnected from his mobile phone
or GPS device until the conference mode is
terminated. Upon termination, Rider B will
automatically re-connect to his mobile phone or GPS.
Rider A and B remain connected to their mobile phones and GPS devices during the 3-way
intercom call.
Set-up and configuration three-way intercom connectivity
PAIRING OPTIONS BETWEEN THREE PARTICIPANTS ( between scala rider G4 models only)
Pairing three G4 headsets is achieved by simply repeating the procedure in the above section TWO-
WAY INTERCOM with a second paired G4 headset (in a different CHANNEL).
Example:
For pairing your G4 with another two G4 headsets:
1. Pair your G4 with the second G4 as in TWO-WAY INTERCOM – (Using CHANNEL A).
2. Pair your G4 with the third G4 as in TWO-WAY INTERCOM – (Using CHANNEL B)
Initiate Intercom calls
There are two ways to start an
Intercom
call with your paired headsets while the headset is in
Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an Intercom call will be
established with both paired headsets, CHANNEL A
and CHANNEL B (if both are available).
The Intercom call will stay on until all participants
CHANNEL BUTTON CONNECT:
Single tap the CHANNEL A Button to
add or remove the CHANNEL A headset
from an Intercom call.
Single tap the CHANNEL B Button to
add or remove the CHANNEL B headset