User's Manual

English
31
RDS ON/OFF (press simultaneously 3 seconds while Radio is on)
• FM Radio ON / OFF (press 3 sec.)
• Switch among pre-saved stations (tap briey)
Searching for and setting new stations
1. While the Radio is on, press and hold the Volume Up or Volume
Down Button for three seconds or until you hear the next station
on your headset.
• Pressing Volume Up will search upwards (higher frequency).
• Pressing Volume Down will search downwards (lower
frequency).
2. Once a station is found, searching stops and you can hear the station.
3. To continue searching, press the Volume Up or Volume Down But-
ton again for three seconds.
4. To save this station, refer to the following section. You may still
continue to listen to the current unsaved station.
Saving a selected station
1. Select the station number from one to six that you wish to set by
tapping the CHANNEL “B” button until the desired station is found.
2. Search for a new station as described in the section above.
3. Tap the CHANNEL “B” button within 20 seconds of nding the sta-
tion to save the current station.
4. To save another station, tap the CHANNEL “B” button again to reach
next station number.
5. If you don’t save the station, the Radio will exit search mode with-
out saving the current station. You can still continue to listen to the
current unsaved station. Tapping the CHANNEL “B” Button in this
case will move to the next saved station.
You can store up to six stations.
7.2 CABLE CONNECTING YOUR MP3 PLAYER OR OTHER
EXTERNAL AUDIO SOURCES
Using the auxiliary line-in port for cable connectivity
Your headset allows you to connect non-Bluetooth audio sources,
such as MP3 players to the headset by using the enclosed cable.
1. Make sure the headset is on Standby mode, ashing slowly in Blue.
2. Connect the MP3 cable to your MP3 player/audio source’s headset
jack and insert the other end of the
cable into the micro USB Connector.
3. Operate the MP3 Player device by us-
ing its own buttons as usual (FF / REW / PLAY / PAUSE).
Volume can be adjusted through the MP3 Player or the Volume
Buttons of the headset.
Any other audio connection will automatically mute the MP3 Player. The
audio signal will return only when headset is once again in Standby mode.
To mute/unmute audio from your MP3 Player, press and hold the
Channel “A” Button for 3 seconds.
NOTE: While listening to your MP3 player, the VOX feature is disabled
QG SRC 131 - QG0160.indd 31 10/20/09 11:29 AM