User's Manual

INTERCOMTOPHONE
In Bluetooth Intercom mode, if a “1+8” Buddy is not in range, or moves out of range, you
have the option to set up the “Intercom-to-Phone” feature via the Cardo Community, to
remain in contact by diverting Intercom calls automatically to your mobile phones.
5.2b INTERCOM WITH CHANNELS “A” AND “B”
Start multi-party conversations using Intercom Channels “A” and “B”. This mode is
suitable for 2, 3 or 4-way calls.
PAIRING INTERCOM CHANNELS “A” AND “B”
Pairing a channel will replace any existing paired device on that Channel with the
newly paired device.
If you have purchased the PACKTALK DUO, both units are factory-paired and congured to
communicate via Channel “A”. If for any reason you have to pair them again, OR if you wish to
pair a dierent unit to make Intercom calls, proceed as follows:
There are three ways to pair Intercom (IC) Channels “A” and “B”:
Â
OPTION 1: Advanced Features Menu
1. Make sure your unit is in Bluetooth Intercom mode and in Standby.
2. Double-tap
Z
to enter the Advanced Features Menu (see 3.3).
3. Select either “Pair Intercom Channel A” or “Pair Interom Channel B”.
☛
OPTION 2: Manual Pairing
1. Check that all units are in Standby.
2. To pair IC Channel A – press v for at least 5 seconds until the RED LED begins
ashing rapidly.
To pair IC Channel B – press v for at least 5 seconds until the RED LED begins
ashing rapidly. Then double-tap v. A ashing BLUE LED indicates Channel “B”
pairing mode.
3. Enter IC Pairing mode on the second unit following its user manual. Both units
will now be in Intercom Pairing mode.
4. After a few seconds, both units will show a solid LED for 2 seconds, indicating that
they are paired and ready to use.
5. If Pairing is not completed within 2 minutes, the units will return to Standby mode.
g
OPTION 3: Via the Cardo SmartSet App (see 3.2)
G
CARDO GATEWAY
Non-Cardo devices can connect via the “Cardo Gateway”, allowing conversation
between your PACKTALK and a non-Cardo brand of Bluetooth intercom.
There are two ways to pair with a non-Cardo brand of Bluetooth intercom:
Â
OPTION 1: Advanced Features Menu
Enter the Advanced Features Menu (see 3.3) and select “Cardo Gateway” to enter
pairing mode on the scala rider.
☛
OPTION 2: Manual Pairing
Enter Intercom Channel “B” pairing mode (see above) and tap p.
Next, enter Mobile Phone Pairing mode on the second unit following its user manual.
After a few seconds, both units will show a solid LED for 2 seconds, indicating that they
are paired.
If Pairing is not completed within 2 minutes, the units will return to Standby mode.
| 13
English