User's Manual

6.3 LISTENING TO MUSIC VIA A2DP
Available only with A2DP/AVRCP compatible Bluetooth audio devices
Play ß
In standby, tap π or use the Voice Command / Feature Menu
Pause/Stop ß
Press π for 2 seconds or use Voice Command
Next Track ß
With music ON, tap π or use Voice Command
Previous Track* ß
With music ON, double-tap π or use Voice Command
Music Scan
With music ON, tap and roll Z forward (scans up) or back (scans down).
The rst few seconds of each audio track will be played.
Stop Scan
To stop the scan on the current track, say any word loudly into the
microphone or tap
π
*With some phones you may need to repeat this action
SWITCHING BETWEEN A2DP AUDIO SOURCES
If two A2DP audio sources are paired, the scala rider will use the default A2DP audio
source. To switch to the other audio source:
1. Stop the music playback from the current device.
2. Start music playback on the other device.
Your scala rider will automatically remember your last played device.
6.4 MUSIC SHARING
Music Sharing allows rider and passenger to listen to the same music within a
range of 33 ft / 10m.
Music Sharing works only in Bluetooth Intercom mode and with A2DP
(Bluetooth stereo) enabled audio sources. In order to share your music with your riding
partner, your scala rider [SENDER] needs to be paired to the other unit [RECEIVER] on
CHANNEL A and the RECEIVER must be in Standby mode.
[SENDER] Start/Stop
sharing your music:
During A2DP music playback, press
v
for 2 seconds
[RECEIVER] Stop music
sharing:
Press
v
for 2 seconds
Phone/Intercom calls and GPS audio navigation will override music playback.
Music Sharing does not transmit voice audio and cannot be used as an Intercom call.
| 17
English