User's Manual

SMARTH Manual
4. Before You Ride
- 28 -
To use a voice command:
1. Confirm you are in the correct mode for your desired voice command.
2. Say the voice command loudly.
4.7 Creating Groups for DMC Intercom
The SMARTH uses Dual DMC™ (Dynamic Meshwork Communication) technology. DMC creates a spontaneous and fluid
virtual network of riders providing seamless group communications. DMC is a more stable connection in a group of
riders than the Bluetooth intercom mode. DMC range is 3.6 km / 2.2 m.
In DMC intercom mode, each rider acts as an autonomous hub that maintains simultaneous and independent
communication links with each of the other members in the group, operating in a mesh network.
Whenever a SMARTH a group member cannot directly connect with group members beyond his DMC intercom range,
DMC readjusts within split seconds re-connecting to the most suitable other group member in order to "leapfrog" to
the remote member.
Any rider can start a new SMARTH DMC group. DMC automatically searches for other riders in DMC intercom grouping
mode and in range then automatically adds them to the group.
Other riders can join, leave, and rejoin existing DMC groups without compromising the integrity of the ongoing multi-
point conference call among the other group members.
4.7.1 Starting DMC intercom Groups
You can start a new DMC intercom group.
To create a new DMC group for SMARTH with Cardo headsets through the headset buttons:
1. Confirm your SMARTH is in DMC intercom mode:
■ Normal battery state - LED flashes green slowly.
■ Low battery state - LED flashes red slowly.
■ Charging - LED flashes purple slowly.
2. Press ~Intercom. The DMC group is created.
To create a new DMC group for SMARTH with Cardo headsets through SmartSet:
1. Make sure that your headset is paired to the mobile device on which SmartSet is installed.
Under tough environmental conditions (dense forest, narrow buildings, heavy traffic), DMC intercom range may
be reduced. Once conditions improve, the range increases again.
SMARTH DMC intercom mode:
is limited to a maximum of four riders
a group can only have one “Group Creator”
a group can have up to three "Group Members"
a "Group Creator" can create up to 6 groups
a "Group Member" can join up to 6 groups
all members should be within 3 meters of the creator for pairing
the group continues functioning even if the Group Creator is no longer available
if a rider's connection is lost the rider remains part of the group and reconnects automatically once in range.
If your SMARTH is not in DMC intercom mode, press ~Intercom and ~Audio.