User guide

ManualsBrandsCardo Systems ManualsHeadphonesS-2TM

microphone must be positioned vertically and not horizontally (Be

sure to clean the selected area prior to the gluing process).

4. Use the pre-moistened Towelette to clean the helmet area where

you want to install the Glue Plate. Allow to dry thoroughly.

5. Peel the foil cover from the Glue Plates’ adhesive pad.

6. Place the Glue Plate into position according to #3. Press rmly 15

seconds on all 3 parts of the Glue Plate.

7. The adhesive pad bonds to full strength over the next 24 hours.

Therefore it is recommended to not use the headset during this 24

hour period.

8. Fasten the Clamp to the Glue Plate using the Allen screws that were

previously removed.

If you have purchased a helmet clamp version with the corded

microphone, please proceed as follows:

ATTACHING THE CORDED MICROPHONE CLAMP ON A

FULL-FACED HELMET

If you are using the corded microphone version, you must rst make sure

your helmet clamp is attached to your helmet as

described in previous section (ATTACHING THE

CLAMP ON THE HELMET). Clean the exact spot on

the internal padding of the helmet, opposite your

mouth, where the microphone will be placed and

proceed as follows.

a. Peel the foil cover from the adhesive Velcro

pad and place the Velcro pad on the chosen

location opposite your mouth.

b. Attach the microphone to the Velcro, as shown

in photo.

c. When done, tighten the screws of the clamp

POSITIONING THE SPEAKERS

Speaker A

Speaker B

Attach the speakers to the Velcro inside

your helmet opposite your ears (short

speaker cord for the left ear [A] and the

long speaker cord [B] for the right ear). You

may want to use the supplied Velcro pad.

Using two speakers inside the helmet

may be prohibited in certain jurisdic-

tions. If this is the case, you should tuck away the long corded

speaker underneath the helmet padding as follows:

Speaker A

Speaker B

Cable

Lead the speaker cord [B]

alongside the rim of the

padding to the right side and

then back to the left side, near

speaker [A]. Then place the

speaker [B] underneath the

padding.

ATTACHING AND REMOVING THE

HEADSET FROM THE HELMET CLAMP

ATTACHING:

Slide the headset downwards along the

sliding panel until a clicking sound

indicates that the headset is locked in

place.

scala rider

™