User's Manual

scala-600™
7
refer to the manual of your mobile phone. To
improve voice tag recognition, use the headset
to record voice tags on your phone.
While your phone is ON but no call is in
progress, press briefly the CTRL button,
followed by a sound. Now pronounce the name
of the party you wish to call and wait for
feedback from the phone. The type of feedback
depends on your phone.
NOTE: After activating the Voice-Dialing
command, you may always cancel the
command by simply tapping CTRL once.
Answering Calls
When you hear the ring tone either on the
headset or on the phone, tap briefly CTRL.
NOTE: With some mobile phone models the
connection might be slightly delayed. In such
case, wait several seconds after pressing CTRL
until you hear a sound on the headset.
Pressing CTRL again too soon, might
disconnect the call.
Terminating Calls
To terminate a call, press briefly the CTRL
button, followed by a sound to confirm the
termination. Wait at least three seconds before
pressing the CTRL button again to place a new
call. Alternatively, you may terminate a call by
using the END key of your mobile phone. If
the other party terminates the call, no further
action on your part is required.
Volume Control
In addition to using the volume controls of
your mobile phone, you can use the Wheel to
adjust the headset's speaker volume.
Increase the
volume
Move the Wheel up by
steps. When you hear a
beep it is at maximum.
Decrease the
volume
Move the Wheel down by
steps. When you hear a
beep it is at minimum.
Mute Function
To activate MUTING: During an ongoing call,
briefly press the center square of the Wheel.
Muting works only with mobile phones that
are equipped with the headset profile. For
phones that support the handsfree profile,
pressing the WHEEL puts the ongoing call into
HOLD. To de-activate either function, tap the
WHEEL again.
Redial
To redial the last number: While no call is in
progress, press the Wheel in quickly and
release.
Call Reject
While no call is in progress and you hear the
ring tone, press and hold CTRL for three
seconds to reject the call and stop the ringing
Call Waiting / Conference
Call
NOTE: This feature works only with mobile
phones that fully support the Bluetooth
"handsfree profile".
• While one call is in progress and there is a
second incoming call (call waiting), tap the
Wheel to put the current call on hold and
accept the second call.
• While one call is in progress and second call
on hold, tap the Wheel to swap the calls.
• While one call is in progress and second call
on hold, press and hold the Wheel for three
seconds to add the held call to a conference
call.
• To TERMINATE one of the calls in
progress, tap briefly the CTRL button.
Doing so will let you continue the second
call in progress.