User Manual

5
6. When prompted by your phone, enter
0000 (4 zeros) as your PIN or
passkey.
7. Your phone will confirm successful
pairing.
NOTE: If pairing is not completed within two
minutes, the headset will return to standby
mode (flashing blue every 3 seconds). To pair,
re-start the process from the beginning.
Congratulations! You have now successfully
completed your Bluetooth pairing process and
are able to use your scala-700 headset in
conjunction with your mobile phone. From
now on, when using your headset, you will no
longer need to pair the headset to the phone,
since the two devices will remain paired until
you delete that pairing from the phone.
Reconnecting the Headset
to a Paired Phone
Although you may have previously paired your
headset to your phone, each time you turn one
of them off, some phones require that you re-
establish the link. Reconnecting may also be
necessary when your headset and phone have
lost the radio signal because the distance
between them has exceeded 30 feet or 10
meters, or major obstacles have come in the
way. After you have turned on your headset
and mobile phone, there are several methods to
re-establish the link if needed:
• Assuming your mobile phone is voice
activation capable, press briefly the
headset’s CTRL button to activate voice
dial. A signal on your phone’s screen will
indicate that the link is re-established.
• Do nothing. Once a call is received, answer
by pressing the CTRL button.
• With some mobile phones you should refer
to your phone’s menu and/or manual.
• The most likely solution is to simply turn off
the headset and then turn on again after
several seconds.
Wearing the Headset
1. Insert the pin of the Ear Loop into the
holding duct of the headset (FIG. 1).
2. Determine the eventual height of the
loop by adjusting the insertion depth
of the pin into the holding duct.
Select a depth, so that when wearing
the headset, the speaker fits snugly
into the opening of your ear canal.
3. Push the Ear Loop away to create an
opening between loop and headset.
4. Place the opened Ear Loop around
your ear and push the headset’s
speaker towards your ear to achieve a
steady and comfortable grip.
5. If needed, bend the flexible bow of
the Ear Loop tighter around your ear.
Changing the Orientation of
the Volume Controls
By default, the Wheel is set for the right ear, so
that moving up on the Wheel increases the
volume, while moving down decreases the
volume (Note the (+) and (-) signs next to the
Wheel).
To change the Wheel orientation from right to
left ear, press the Wheel and Control button for
at least three seconds while the headset is
turned off. The red and blue LED will flash for
two seconds as confirmation for the change.
6. Handling Calls
Initiating Calls
NOTE: Certain advanced features of the scala-
700 are only accessible to phones equipped
with the "hands-free" profile. Please check if
your phone supports both the "headset profile"
and the "hands-free profile".
Initiating calls by using your
phone’s keypad
1. Dial the desired phone number.
2. Press “Talk” or “Send” on your
phone to dial the number.