User manual
28
3. Close the red button, making sure it is still inside its black holding ring.
NOTE: Optional speaker pads are provided to boost the speaker volume if needed by
bringing the speakers closer to your ears.
To use, simply place the speaker pad between the Velcro pad in the helmet
indentation and the speaker.
5.5 POSITIONING THE MICROPHONE
Locate the spot on the internal padding of the helmet, opposite your mouth,
where the microphone will be placed.
1. Peel the cover from the adhesive Velcro pad and place it on the chosen
location opposite your mouth.
2. Attach the microphone to the Velcro, as shown in illustration.
3. If there is any excess microphone cable, tuck it under the cheek pads.
5.6 REMOVING THE SRCSYSTEM™ FROM YOUR HELMET
1. Detach both speakers and the microphone from the Velcro on the helmet.
IMPORTANT: Make sure not to pull on the Antenna connector.
2. Lift and push the collar’s arch from the front helmet area to carefully remove
the SRC-System™ from the helmet.
3. Pull out the Antenna connector from its pocket and carefully disconnect it.
5.7 WEARING AND REMOVING THE HELMET
The electronic components of SRC-System™ are safely embedded inside an
Acoustic Collar. To avoid discomfort while you put on your helmet or while
removing it, we recommend that you proceed as follows:
1. Expand the helmet opening by rmly holding the chin straps and pulling
them forcefully apart.
2. While pulling the straps apart, slide the helmet
over your head.
3. To remove the helmet, proceed along the same
lines by rst pulling the straps apart and then
pushing the entire helmet upwards.
NOTE: Your SRC-System™ Acoustic Collar is designed for maximum comfort.
However, since it contains an entire electronic kit within, it will have a slight a bulge.
Therefore, putting your SRC equipped helmet on or taking it o may feel dierent
than what you are used to with a standard Acoustic Collar. Remember: The more
you pull the helmet straps apart when putting on your helmet or taking it o, the
smoother the process will be, allowing the Acoustic Collar to soften.
5.8 CLEANING THE SRCSYSTEM™ ACOUSTIC COLLAR
To clean the SRC-System™ Acoustic Collar, rst make sure the USB connector is
tightly closed. Use only a slightly damp cloth. Avoid soaking the Acoustic Collar
with water or any other uid. Never submerge it and refrain from letting water
come in contact with the speakers or the microphone. Allow the unit to dry at
room temperature.