User guide

English

c. Press and hold CHANNEL (“A”) BUTTON on both G4s for at least

six seconds until the G4’s BLUE or RED Light begins ashing

rapidly, indicating that they have entered the Intercom Pairing

mode (See Table in section 9.10).

d. Release the buttons and wait until both G4s display a solid light

for two seconds, indicating that the two G4s are now paired for

Intercom connection. (This may take up to two minutes).

Step Two: Pair Driver 3 to Passenger 4 via Channel “A”

Repeat the above pairing procedure between Driver 3 and Passenger 4.

Step Three: Pair Passenger 2 to Passenger 4 via Channel “B”

Repeat the above pairing procedure between Passenger 2 and

Passenger 4 using the Channel “B” button. (instead of Channel “A”

button as described in point "c" of Step One above).

Your 4-Way Conference Intercom Pairing is now complete and ready

to use.

NOTE: If the Pairing process is not completed within two minutes the G4s

will return to Standby mode.

Making 4-Way Intercom calls

Once you have successfully paired the four G4s as described above,

and all units are in standby mode, proceed as follows to start a 4-way

Conference Intercom call:

a. Passenger 2 should press Button “B” to initiate a call with

Passenger 4. Wait until audio is heard on both G4s and proceed

to the next step.

b. Driver 1 should press Button “A” to initiate a call with Passenger 2.

c. Driver 3 should press Button “A” to initiate a call with Passenger 4.

Now the 4-way intercom conference mode is established.

NOTE: If one of the G4s should disconnect or drop o from the 4-way call and

fails to reconnect, repeat the three steps above in that precise order.

scala rider

PowerSet