User guide

ManualsBrandsCardo Systems ManualsHeadphonesSCALA RIDER G4 POWERSET

English

Initiate Intercom calls from scala rider G4

There are two ways to start an Intercom call with your paired headsets

while the G4 is in Standby mode:

VOICE CONNECT:

Start talking loudly

Once you start talking loudly, an

Intercom call will be established with

both paired headsets.

The Intercom call will stay on until all

participants remain silent for 30 seconds.

CHANNEL BUTTON

CONNECT:

Single tap the chosen

Channel Button to add or

remove the unit from an

Intercom call.

Initiate Intercom calls from:

Q2 pro: Tap the MC Button once on a Q2 pro unit to open an intercom

call. To terminate the call, tap once.

Q2: Tap the MC Button twice on a Q2 unit to open an intercom call.

Wait 3 seconds between taps. To terminate the call, tap once.

Other scala rider models: Tap the headset CTRL Button to open/

close intercom call.

9.11c. THREE WAY INTERCOM WITH OTHER SCALA RIDER

MODELS

In terms of range, the 3-Way Intercom between your G4 and

other scala rider units achieves distances of the lowest common

denominator. For example, connecting your G4 with two Q2 pro units

will enable intercom distances of maximum 2,300 ft / 700m.

NOTE: When connected to earlier scala rider headsets (e.g. a “Solo”, “FM”,

"TeamSet pro" or a “TeamSet” Driver unit) only Rider-to-Passenger mode is

available.

All options are in Full Duplex, meaning that all parties can speak and

hear one another simultaneously, similar to mobile or landline phone

conversations and unlike walkie-talkie communications.

Using the G4 with two Q2/Q2 pro headsets:

Proceed with setup as in section 9.11a above and use either in Rider-

to-Passenger or in Bike-to-Bike mode.

Using the G4 and scala rider

Q2/Q2 pro with either a Solo, FM,

TeamSet pro or TeamSet (Driver) headset:

Q2/Q2 pro: Proceed with setup as in section 9.11a above and use in

Bike-to-Bike mode.

Solo, FM, or TeamSet (Driver): Proceed with setup as in section

9.11b above but use only in Rider-to-Passenger mode.

Example:

To pair your G4 with a Q2 and an FM headset:

1. Pair your G4 with the Q2 as described in section 9.11a., using

CHANNEL “A”.

2. Pair your G4 with the FM as described in section 9.11b., using

CHANNEL “B” (For Rider-to-Passenger use only).

Using your G4 with another G4 and another scala rider model

(such as a Q2/Q2 pro, Solo, FM, TeamSet pro or TeamSet [Driver])

1. Proceed with setup as in section 9.10b above for pairing the

second G4.

2. Proceed with setup as in section 9.11a or 9.11b above according

to the headset you want to use.

Example:

To pair your G4 with another G4 and a scala rider FM headset:

1. Pair your G4 with the second G4 as described in section 9.10a.,

using CHANNEL “A”.

2. Pair your G4 with the FM as described in section 9.11b., using

CHANNEL “B” [For Rider-to-Passenger use only].

scala rider

PowerSet