User guide

4
scala rider
®
Solo
™
Wall Charger
Allen Wrench
Velcro Pads
MP3 Cable
MP3 Cable Holder
Glue Plate
Pre-moistened Towelette
Carry-Pouch
Microphone sponges
Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, including Warranty and Registration form
IMPORTANT:
The scala rider Solo is a water-resistant device, designed for use
under moderate rain or snow conditions. However, the headset is not
waterproof and should not be used under severe weather conditions.
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
BEFORE USING (CHARGING THE HEADSET)
Make sure that the headset is fully charged for at least four hours
before initial use.
1. Connect the wall charger to the headset’s Charging Jack
(located between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to
15 seconds until the Red Light turns on). When charging is
complete, the Red Light will turn o.
SET UP AND CONFIGURATION
SET UP FOR MOBILE PHONE CALLS
If you have a Bluetooth enabled mobile phone and would like
to make and receive phone calls using the scala rider Solo,
you must rst pair your headset to the mobile phone.
Pairing is a one time process. Once the headset is paired to a specic
mobile phone during this Setup Procedure, they will remain paired
and automatically recognize each other whenever they are within
range. If the connection between the phone and headset is lost, tap
the CTRL button to reconnect the devices.
TO PAIR THE SCALA RIDER SOLO TO A BLUETOOTH MOBILE PHONE
1. Turn on your phone and make sure its Bluetooth function is activated.
2. With the scala rider Solo headset turned OFF, press and hold the
CTRL Button until the Red and Blue Lights begin rapidly alternating.
3. Search for Bluetooth devices on your phone by following the
phone’s instructions. Please consult your phone’s User Manual for
more information.
Mobile Phone
GPS
MP3 Player