™ TeamSet ™ communication in motion ™ Guide d’Utilisation Guia do Usuário Handleiding Инструкция пользователя User Guide
scala rider® TeamSet™
Congratulations, and thank you for choosing the scala rider TeamSet Bluetooth® Headset package for Motorcycle helmets. The retail box of the scala rider TeamSet contains two headset units: one headset for the driver and a second headset for the passenger: The Driver’s unit includes a Bluetooth module that allows the following uses: 1. Bluetooth headset for mobile phone communication*, supporting Headset* and Handsfree* profiles (10m / 33 ft. range) 2.
SET UP AND CONFIGURATION Wall Charger Driver-to-Passenger Full Duplex Intercom Connection (10 m/30 ft.
With some mobile phones, you may need to tap the CTRL button to connect the headset to the phone after pairing is complete. The scala rider TeamSet headset will automatically connect to the last phone connected to the headset.
ATTACHING THE CLAMP ON THE HELMET Perform this procedure for both the driver and the passenger helmets. The Helmet Clamp must be attached to the left side of the helmet. Once attached, the headset unit can be mounted or released from the Helmet Clamp at any time. If you wish to connect your MP3 player to you headset, please refer first to the assembly instructions listed in section: USING THE MP3 PLAYER WITH YOUR HEADSET.
indicates that the headset is locked in place. REMOVING: Your headset can be removed for charging and storage by pressing your finger gently against the tab and sliding the headset up with the other hand. We recommend that you remove the headset from the helmet when not in use. Attach the speakers to the Velcro inside your helmet opposite your ears (short speaker cord for the left ear [A] and the long speaker cord [B] for the right ear). You may want to use the supplied Velcro pad.
MP3 cable holder. For this purpose please proceed as follows: 1. Use the enclosed Allen Wrench to remove both Allen screws from Helmet clamp and release the clamp’s back plate. 2. Place the MP3 cable holder on the helmet clamp. Both pins on the MP3 cable holder should be fixed into corresponding indentations on clamp. 3. Place the Back Plate on top of the MP3 cable holder hook MP3 cable holder and secure all parts together using the Allen screws that were previously removed, as shown in photo. 4.
Note: The VR feature works well while driving up to 70km/h or 44m/h with 3/4 helmet and up to 120km/h or 75m/h with a closed full-faced helmet. PHONE FUNCTIONS Answer a call Tap the CTRL Button or speak loudly any word of your choice. Reject a call Tap the Intercom Button or remain silent for 15 seconds during an incoming call. Terminate a call Press and hold the Intercom Button for 3 seconds when a call is in progress. For some mobile phones you may need to press the Control button to end the call.
PASSENGER’S UNIT FUNCTIONS USING THE HEADSET DESIRED RESULT: Turn on the headset Turn off the headset Start using the Intercom Terminate operation of Intercom Enable/disable Always-on Intercom Increase Intercom volume Decrease Intercom volume REQUIRED ACTION: Press the CTRL Button steadily for at least 3 seconds. Led indication: three blue flashes. Audio feedback: Ascending tone (low-high). Press the CTRL Button steadily for at least 3 seconds. Led indication: three red flashes.
IC RF Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2) this device must accept any interference, including interference that may cause undesired operation of the device.
(including attorneys fees) and holding Cardo harmless for any bodily injuries, harm or death as well as losses or damages in goods, to any Vehicles including your own, or to any property or asset that belong to you or to third parties, any of which may result from using the Device under any circumstances or conditions and irrespective of jurisdiction.