User guide

PASSENGER’S UNIT FUNCTIONS
USING THE HEADSET
DESIRED RESULT: REQUIRED ACTION:
Turn on the headset Press the CTRL Button steadily for at least 3
seconds. Led indication: three blue ashes.
Audio feedback: Ascending tone (low-high).
Turn o the headset Press the CTRL Button steadily for at least 3
seconds. Led indication: three red ashes.
Audio feedback: Descending tone (high-low).
Start using the Intercom During standby, start talking loudly to
activate the Intercom
Terminate operation of
Intercom
Stop talking. The audio connection will be
terminated within 25 seconds.
Enable/disable Always-on
Intercom
During standby tap the Control Button.
One tone = intercom enabled. Two tones =
intercom disabled.
Increase Intercom volume Tap the Volume Up Button
Decrease Intercom volume Tap the Volume Down Button
Note: In case the person on the other side of the intercom is not responding and
you start talking, 2 beeps will alert you that the other side is not available
STATUS LIGHTS
STATUS LIGHT STATUS
None Headset is o
One blue ash every 3 seconds Headset is on
Steady red (Charger is connected) Headset is being charged
Steady red (Charger is not
connected)
Headset in Intercom pairing
mode
SUPPORT
For additional information please visit our website at
www.cardosystems.com
FAQ: www.cardosystems.com/faq
or contact us at:
[e-mail]
Phone: USA and Canada: + 1-800-488-0363
International: [phone]
NOTICES
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modications not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
10
scala rider
®
TeamSet
™