Owner's Manual

5.2 INTERCOM CONFERENCE MODE
Start multi-party conversations using the Channel A and B buttons
on your G9. This mode is suitable for 2, 3 or 4-way calls.
Pairing between scala rider G9s can be done either via
Flash-Pairing (see below) or by manually pairing A and B as
described in the following sections.
INTERCOM CHANNELS AND PAIRING LED INDICATION
CHANNEL PAIRING BUTTON LED INDICATORS
“A” Channel “A” BUTTON Rapid RED ashing
“B” Channel “B” BUTTON Rapid BLUE ashing
5.2a TWOWAY INTERCOM
If you have purchased the G9 PowerSet, both units are factory-
paired and congured to communicate via their respective
Channel “A” Buttons. If for any reason you have to pair them
again, OR if you purchased a single scala rider G9 and wish to
pair with a second unit to make Intercom calls, proceed as follows:
METHOD 1: Flash-Pairing with Channel A / B buttons
1. Remove two G9 units from the Audio Kits and verify
they are in Standby Mode (slow single blue ashing).
2. Tap the Channel button (“A” or “B”) on the rst G9 unit and the
LED begins ashing.
3. Tap the Channel button (“A” or “B”) on the second G9 unit and
the LED begins ashing.
NOTE: Selecting a Channel that is already in use will override the
existing paired device on that Channel with the newly-paired device.
4. Within 5 seconds of tapping a Channel button, bump the two G9
units gently against each other and hold them side by side.
CLICK !
5. If Flash-Pairing was successful, a purple light appears for 2 seconds.
☛
METHOD 2: Manual Pairing with Channel A / B buttons
1. Check that both G9s are ON and in Standby mode (single BLUE
ash every 3 seconds).
2. Choose a channel to pair the G9 unit (Channel “A” or “B”).
NOTE: Selecting a Channel that is already in use will override the
existing paired device on that Channel with the newly paired device.
3. Press the chosen Channel Button (“A” or “B”) on the rst G9 for at
least 5 seconds until the BLUE or RED LED begins ashing rapidly,
indicating it is in Intercom Pairing mode (see table in section 5.2).
4. Immediately repeat Steps 2-3 for the second G9 unit. Both units
will now be in Intercom Pairing mode.
5. After a few seconds, both G9s will show a solid light for
2 seconds, indicating that they are paired, connected and
ready to use.
NOTE: If Pairing is not completed within two minutes, the G9 will
return to Standby mode.
10 | scala rider
®
G9 / G9 PowerSet 10 | scala rider
®
G9 / G9 PowerSet