Owner's Manual

5.2b THREEWAY INTERCOM
If you purchased the scala rider G9 PowerSet, both units are
factory-paired and congured to communicate via their respective
Channel “A” Buttons. To pair a third scala rider G9 use Channel “B”.
To set up three-way intercom conference mode proceed as
follows:
Use Channel “B”
Use Channel “A”
Rider 2
Rider 3
Rider 1
Rider “1” is paired to Rider “2” and also to Rider “3”.
PAIRING THREE SCALA RIDER G9 UNITS
1. Rider 1 pairs their device to Rider 2 using Channel “A” as
described in section 5.2a.
2. Rider 1 pairs their device to Rider 3 using Channel “B” as
described in section 5.2a.
The Three-Way Conference Intercom Pairing is now complete and
ready to use.
IMPORTANT: Three-Way Conference Mode Considerations
During a 3-Way Intercom Conference call with 2 other participants,
Rider 1 will not be able to receive mobile phone calls or GPS
navigation instructions as long as the call is in progress.
5.2c FOURWAY INTERCOM
To set up four-way intercom conference mode proceed as follows:
In this conguration the two passengers (numbered 2 and 4) are
each using two Bluetooth connections:
Passenger 2 is paired to Rider 1 and to Passenger 4
Passenger 4 is paired to Rider 3 and to Passenger 2
PAIRING FOUR SCALA RIDER G9 UNITS
1. Pair Rider 1 to Passenger 2 using Channel “A” (see 5.2a).
2. Pair Rider 3 to Passenger 4 using Channel “A” (see 5.2a).
3. Pair Passenger 2 to Passenger 4 using Channel “B” (see 5.2a).
The Four-Way Pairing is complete and ready to use.
IMPORTANT: Four-Way Conference Mode Considerations
During a 4-Way Intercom call, the two passengers who maintain two
active connections simultaneously will not be able to receive mobile
phone calls or GPS instructions as long as the conference call is in
progress.
English
scala rider
®
G9 / G9 PowerSet | 11 scala rider
®
G9 / G9 PowerSet | 11