Owner's Manual
6.5 RECEIVING INTERCOM CALLS
If another paired scala rider G9 tries calling you via Intercom, the
call will begin almost instantly.
6.6 BUSY SIGNAL
When attempting to establish an Intercom call with another device
that is already busy, a busy signal will be heard. The G9 is busy
while on a phone call, intercom call with Channels “A” and “B”,
“One+8” intercom call or Click-to-Link call.
6.7 GROUP SIGNAL
Send an instant message to all paired G9s within a range of
up to 350 m / 1,150 ft. The recipients will hear a “Signal!”
voice announcement. To reach a maximum number of riders, the
message is automatically forwarded to all paired G9s within the
recipient’s range. In this manner the total range is extended to up
to 1 km / 3,280 ft.
Send a Group Signal Double tap “VC”
NOTE: The transfer of wireless signals is subject to multiple external
factors. Therefore, users may use but should not rely on the Group
Signal for emergency purposes.
6.8 VOICE CONNECT VOX
The G9 oers VOX technology for safe and hands-free
operation of some key functions.
In the Cardo Community you can set VOX to either start an
intercom call or activate the Voice Command.
VOX Activation Speak any word loudly into the microphone
Answer a
phone call
Speak any word loudly into the microphone
(e.g. “hello”).
Reject a
phone call
Remain silent for about 15 seconds
VOX Sensitivity
(Default: Medium)
Adjust via the Voice Menu or the Cardo Community.
High: Use this setting if it is dicult to activate VOX
Low: Use this setting if it is too easy to activate VOX
VOX Operation
Mode
VOX can be set to activate the Voice Command
(default) or to start an Intercom Call via the
Cardo Community
Enable/Disable
VOX
(For Intercom/Voice
Command only)
Press “V+” and “V-” simultaneously for 2 seconds
• Enable: Blue ash for 2 seconds
• Disable: Red ash for 2 seconds
14
| scala rider
®
G9 / G9 PowerSet
14
| scala rider
®
G9 / G9 PowerSet