Owner's Manual

7.1c HOT DIAL
Call a pre-programmed phone number automatically at the push of
a button.
1. Congure your G9’s Hot Dial number via the Cardo Community at
http://community.cardosystems.com (see Section 3)
2. To call your Hot Dial number, double tap “B”.
7.2 PAIRING A GPS DEVICE
NOTES:
• Not all Bluetooth GPS devices allow connections to Bluetooth
audio devices. Please consult your GPS User Manual for more
information.
• If Pairing is not completed within 2 minutes, the scala rider G9 will
return to Standby mode.
1. Turn on your GPS.
2. Check the G9 is in Standby (single BLUE ash every 3 seconds).
3. Press “V+” for at least 5 seconds, until the PURPLE light begins
ashing rapidly.
4. Search for Bluetooth devices on the GPS device by following the
instructions in the GPS User Manual.
5. Once your GPS lists the scala rider G9 as a discovered device,
select it.
6. If prompted for a PIN or Passkey, enter 0000 (four zeros).
7. Your GPS will conrm that pairing has succeeded and the scala rider G9
will begin ashing slowly in BLUE.
IMPORTANT: If you wish to use a mobile phone and GPS device with
the scala rider G9, pair the mobile phone directly to the GPS device.
7.3 MUSIC STREAMING VIA A2DP
NOTE: The scala rider G9 can also receive audio via
the enclosed cable from non-Bluetooth MP3 Players or
audio sources as described in section 7.4.
1. Turn on the Music Player and make sure that Bluetooth function
is activated.
2. In Standby, press “MB” for 6 seconds. The G9 will rst ash RED.
Continue to hold the button until the RED and BLUE lights begin
rapidly alternating.
3. Search for Bluetooth device on the Music Player by following the
device’s instructions.
4. Once your Music Player lists the “scala rider G9” as a discovered
device, select it.
5. If prompted for a PIN or Passkey, enter 0000 (four zeros).
6. The Music Player may conrm that pairing has succeeded, and
the scala rider G9 will begin ashing slowly in BLUE.
NOTE: If Pairing is not completed within 2 minutes, the G9 will
return to Standby mode.
Available only on AVRCP compatible Bluetooth audio sources
Play Press “A” for 2 seconds
Pause/Stop Press “A” for 2 seconds
Next Track Press “V+” for 2 seconds
Previous Track* Press “V-” for 2 seconds
*With some phones you may need to repeat this action
16 | scala rider
®
G9 / G9 PowerSet 16 | scala rider
®
G9 / G9 PowerSet