Owner's Manual

SWITCHING BETWEEN A2DP AUDIO SOURCES
If a Music Player is paired, the scala rider G9 will use it as the
default A2DP audio source.
1. Stop the music playback from the current device.
2. Start music playback from the other device.
7.4 MUSIC VIA THE AUX
The AUX is used to connect a non-Bluetooth audio source with a
3.5 mm / ⁄” stereo jack using the enclosed cable.
AUX
1. Check the G9 is in Standby (single BLUE ash every 3 seconds).
2. Connect the MP3 cable to the Music Player’s jack and insert the
other end of the cable into the AUX.
To listen to music from a cable-connected device, operate the
Music Player using its buttons as usual (FF/REW/ PLAY/PAUSE).
8. FM RADIO
Your scala rider includes a built-in FM radio with a
6 Preset memory and RDS (Radio Data System).
8.1 GENERAL FUNCTIONS
Turn on Radio In standby, press “B” for 2 seconds
Turn o Radio Press “B” for 2 seconds
Next Station With radio on, press “V+” for 2 seconds
Previous Station With radio on, press “V-” for 2 seconds
Preset stations can be saved via the Cardo Community or directly
from your G9.
1. Turn on the Radio.
2. Select a Preset number you wish to set (Preset 1 – 6) by tapping
“B” until the desired Preset is heard.
3. Find an FM station to save using Seek or Scan (see 8.2 RADIO
TUNING).
8.2 RADIO TUNING
Seek and Save: (Find the next FM station)
1. Press “V+” or “V-” for 2 seconds.
• “V+” searches upwards (higher frequency) for a station
• “V-” searches downwards (lower frequency) for a station
2. Tap “B” within 20 seconds of nding the FM station to save it as
the current Preset.
Scan and Save: Scan through FM stations
1. Press “V+” for 5 seconds. The G9 will search upwards (higher
frequency) for a station. When a station is found, it can be heard
for a few seconds.
English
scala rider
®
G9 / G9 PowerSet | 17 scala rider
®
G9 / G9 PowerSet | 17